Installation & Tutorials » Horizontal Bends » Elbows
Elbows
FLEXTRAY can be cut and formed on-site into nearly any configuration by cutting the bottom and side wires of the straight sections. After removing the cut wires, a radius can be bent and fastened with appropriate hardware. The following illustrates just a few suggested methods for creating bends. Please refer to your cable manufacturer’s cuggested bend radius when forming FLEXTRAY.
Short Radius Bend
For short radius bends, remove one section and both side rails.
Long Radius Bend
For long radius bends, remove every other section.
Bend Options
Click on a width to view options (PDF).
Please note, in order to properly view the following PDF’s, you must download and install the free Adobe Reader.